YumaPro SDK 17.10 introduces support for the Call Home protocol defined in IETF RFC 8071

By default, Call Home is not enabled but must be configured by the developer/user.


--with-callhome=boolean

              This feature is only available if the server image is built with

              the  flags  WITH_CALLHOME=1.   If  set  to 'true', then the IETF

              Callhome for SSH feature will be enabled.  If  set  to  'false',

              then this feature will be disabled and the following CLI parameters will be ignored:

                           - callhome-retry-max

                           - callhome-retry-interval

                           - callhome-server

                           - callhome-sshd-command

                           - callhome-sshd-config

                           - callhome-subsys-command

              The default value for with-callhome is 'false'.


The with-callhome parameter can be used to turn the Call Home parameter on via the command line

when starting up netconfd-pro:


user@system> netconfd-pro --with-callhome=true


or Call Home can be set in the configuration file for netconfd-pro, defualt location is /etc/yumapro/netconfd-pro.conf:


#### leaf with-callhome
# This feature is only available if the server image
# is built with the flags WITH_CALLHOME=1.
# If set to 'true', then the IETF Callhome for SSH
# feature will be enabled. If set to 'false', then
# this feature will be disabled.
#
# with-callhome false
#
with-callhome true


For more information on using the Call Home protocol in YumaPro SDK please refer to the Solution Article "Establishing a Call Home Connection" and also to IETF Call Home of the YumaPro netconfd-pro Manual.